e-ISSN 2393-9877•p-ISSN 2394-2444•Quarterly•Open Access•IF 5.99
Track PaperUpload ReceiptContact
IJAREST logoIJARESTInt. Journal of Advance Research in Engineering, Science & Technology

CAD MODELING AND STRESS ANALYSIS OF HUMAN TOOTH USING FINITE ELEMENT METHOD

Vinayak R.Tayade

P.G.Student, Department of Mechanical Engineering, S S G B COE&T, Bhusawal, Maharashtra, (India), India

IJAR-2016-267277Vol. 3, Issue 7July 2016Pages 20-29

Abstract

In the present modern era, every human is concerned about dental health and look. It represents ones personality in the social field. Various functional loads create stresses inside the tooth which governs failure of tooth. To study the stress of critical part of human body, the field of dentistry popularly applies important branch of engineering “Biomechanics”. Traditional dentistry have many restrictions for image analysis these methods are confined to only 2D , on the other front traditional stress analysis confined to only methods of strain gauge, Photo elasticity and 2D Finite Element analysis. These traditional methods resulted in inability of finding solution for complex behavior of human tooth. These methods are unable to carry stress analysis of human’s real tooth in 3D as well these methods are time consuming and not accurate. Present work finds scope to reproduce CAD model and carry stress analysis of human’s real tooth. The scope covers critical factors of tooth like irregular geometry, complex material properties and complicated loading conditions in 3D to bring accurate results in short time. There is a scope to perform analytical stress calculation of complex geometry of tooth. Present work overcomes past restrictions by image processing and reproducing actual 3D tooth model of human’s real Molar tooth by the use of CT scan and suitable biomedical imaging software 3D Doctor. The reproduced 3D model is used for FE analysis with the use of FEA software ANSYS. As the Analytical approaches are not available for complex dental structures the stress analysis is done by analytical method too. Present study revealed that, the use of CT scan and 3D doctor software enabled to generate accurate 3D CAD model of actual humans tooth. This obtained exact solution, better visualization for actual tooth subjected to loads of mastication. Stress analysis results quantified the stress value and confirmed that stress due to bending load is higher compared to axial load. Use of FEA tool for such complex geometry and complex loading conditions overcomes the limitations of experimental and analytical approaches used for stress analysis. The methodology adopted in this study adds value to investigate optimal designs for dental implant in shortest time. This also helpful for treatments & complicated surgeries for Bio medical, Dentistry field & Skeletal Anchorage System (SAS) of human body in shortest time.

Keywords

How to cite

APA
Vinayak R.Tayade (2016). CAD MODELING AND STRESS ANALYSIS OF HUMAN TOOTH USING FINITE ELEMENT METHOD. IJAREST, 3(7), 20-29.
BibTeX
@article{ijarest2016267277,
  title={{CAD MODELING AND STRESS ANALYSIS OF HUMAN TOOTH USING FINITE ELEMENT METHOD}},
  author={Vinayak R.Tayade},
  journal={IJAREST},
  volume={3},
  number={7},
  pages={20-29},
  year={2016}
}

Published under an open-access licence. See copyright & licensing.

✆