e-ISSN 2393-9877•p-ISSN 2394-2444•Quarterly•Open Access•IF 5.99
Track PaperUpload ReceiptContact
IJAREST logoIJARESTInt. Journal of Advance Research in Engineering, Science & Technology

Study the effect of various parameters of an Electrical Discharge Machining – A review

Jay k. Lad, Mihir A. Patel, Devarsh P. Upadhyay, Chirag N. Dabhi, Samarth Bhaduwala

Student (B.E) Mechanical, ITM UNIVERSE, VADODARA, India

IJAR-2016-027BC3Vol. 3, Issue 2February 2016Pages 203-212

Abstract

Electrical discharge machining (EDM) is regarded one of the dominant non-conventional machining processes. It is based on thermoelectric power between the work piece and tool. The process includes a controlled erosion of electrically conductive work piece by the introduction of rapid and repetitive spark discharge between the tool and work piece by the use of dielectric fluid. To generate a spark between the workpiece and the tool two conditions must be full filled as one is to have air gap between them and second is both of them have good electrical conductivity. There are various types of products which can be produced using EDM such as dies and moulds. Parts of aerospace, automotive industry and surgical components can be finished by EDM. This research paper reviews the vast array of electrical discharge machining and its various parameters such as material removal rate and surface finish.

Keywords

How to cite

APA
Jay k. Lad, Mihir A. Patel, Devarsh P. Upadhyay, Chirag N. Dabhi, Samarth Bhaduwala (2016). Study the effect of various parameters of an Electrical Discharge Machining – A review. IJAREST, 3(2), 203-212.
BibTeX
@article{ijarest2016027BC3,
  title={{Study the effect of various parameters of an Electrical Discharge Machining – A review}},
  author={Jay k. Lad and Mihir A. Patel and Devarsh P. Upadhyay and Chirag N. Dabhi and Samarth Bhaduwala},
  journal={IJAREST},
  volume={3},
  number={2},
  pages={203-212},
  year={2016}
}

Published under an open-access licence. See copyright & licensing.

✆