OPTIMIZATION OF HOT MACHINING PROCESS PARAMETERS FOR EN24 MATERIAL
Ravindra Patel, Assistant Prof. A.S.Patel, Assistant Prof. U.J.Patel
Department of Mechanical Engineering, L.C.I.T-Bhandu,Mahesana,Gujarat, India
Abstract
In the modern world, there is a need of materials with very high hardness and shear strength in order to satisfy industrial requirements. So many materials which satisfy the properties are manufactured. Machining of such materials with conventional method of machining was proved to be very costly as these materials greatly affect the tool life. So to decrease tool wear, power consumed and increase surface finish Hot Machining can be used. Here the temperature of the work piece is raised to several hundred or even thousand degree Celsius above ambient, so as to reduce the shear strength of the material. Various heating method has been attempted, for example, bulk heating using furnace, area heating using torch flame, plasma arc heating, induction heating and electric current resistance heating at tool-work interface. The experiment is conducted on conventional lathe. The temperature is controlled by a infa-rate thermometer and flame heating system. The statistical analysis is done by Taguchi method. Taguchi designs provide a powerful and efficient method for designing products that operate consistently and optimally over a variety of conditions. The primary goal is to find factor settings that minimize response variation, while adjusting (or keeping) the process on target. A process designed with this goal will produce more consistent output. A product designed with this goal will deliver more consistent performance regardless of the environment in which it is used.Taguchi method advocates the use of orthogonal array designs to assign the factors chosen for the experiment. The L9 orthogonal array of a Taguchi experiment is selected for four parameters (speed, feed rate, depth of cut and temperature) with three levels (low, medium, and high) in optimizing the hot machining turning parameters on lathe. The signal-to-noise (S/N) ratio, analysis of variance (ANOVA) and grey relational analysis were employed to the study the performance characteristics in the turning of EN24 material. Form the experiment it is found that temperature is most effective parameter for surface roughness and tool wear, while cutting speed is most effective parameter for material removal rate.
Keywords
How to cite
Ravindra Patel, Assistant Prof. A.S.Patel, Assistant Prof. U.J.Patel (2015). OPTIMIZATION OF HOT MACHINING PROCESS PARAMETERS FOR EN24 MATERIAL. IJAREST, 2(5), 168-171.
BibTeX
@article{ijarest201578D4A3,
title={{OPTIMIZATION OF HOT MACHINING PROCESS PARAMETERS FOR EN24 MATERIAL}},
author={Ravindra Patel and Assistant Prof. A.S.Patel and Assistant Prof. U.J.Patel},
journal={IJAREST},
volume={2},
number={5},
pages={168-171},
year={2015}
}Published under an open-access licence. See copyright & licensing.