DESIGN SIMULATION AND DEVELOPMENT OF ELECTRONIC TAP CHANGER DESIGN AND ANALYSIS
Meet Patel, Viral Desai, Shivang Desai, Nilesh Jaiswal, Mulav Rathod
Student, Department of Electrical Engineering, SVIT-Vasad, India
Abstract
By implementation of our project, we can change different voltage taping in any power transformer as required without any production of arcs by using thyristor modules. The design employs a low-voltage high-current switch-mode amplifier to divert current out of the mechanical contacts and into a pair of anti-parallel thyristors.The controlled source is switch mode in nature, employing four low-voltage, high-current devices in an H-bridge configuration. Thyristor module and control source are used for tap changing and with the help of the control source we can divert the load current to solve the problem of arcing at switching period. Control source acts as current and voltage source as per requirement. The inductor is included so that current-source behavior may be produced through suitable closed -loop control of the H-bridge duty cycle when one of the two switches (or) is closed and are present to define the voltage when both switches are open. Thus the operating device can be termed as Active Shunt Diverter.
Keywords
How to cite
Meet Patel, Viral Desai, Shivang Desai, Nilesh Jaiswal, Mulav Rathod (2015). DESIGN SIMULATION AND DEVELOPMENT OF ELECTRONIC TAP CHANGER DESIGN AND ANALYSIS. IJAREST, 2(4), 126-130.
BibTeX
@article{ijarest20156DBD63,
title={{DESIGN SIMULATION AND DEVELOPMENT OF ELECTRONIC TAP CHANGER DESIGN AND ANALYSIS}},
author={Meet Patel and Viral Desai and Shivang Desai and Nilesh Jaiswal and Mulav Rathod},
journal={IJAREST},
volume={2},
number={4},
pages={126-130},
year={2015}
}Published under an open-access licence. See copyright & licensing.