TO IMPROVE THE QUALITY OF HINGE PRODUCT AND REDUCE THE RATE OF REJECTION AND WASTAGE ON POWER PRESS MACHINE

Authors

  • Dhruv A. Patadiya Department of Mechanical Engineering, SPNVTC Surendranagar, Gujarat 363-.030, India
  • Jayvirsinh A. Zala Department of Mechanical Engineering, SPNVTC Surendranagar, Gujarat 363-.030, India
  • ignesh R. Chauhan Department of Mechanical Engineering, SPNVTC Surendranagar, Gujarat 363-.030, India
  • Jaspalsinh M. Rana Department of Mechanical Engineering, SPNVTC Surendranagar, Gujarat 363-.030, India

Keywords:

press tool, die, hinge, blanking, piercing

Abstract

we observed that at BINA STEEL INDUSTRIES at Surendranagar, to the rate
of rejection of hinges product is about 1/8 in industry & the wastage of the raw material (steel 202)
of hinge part are much more. This is a very small scale industry currently they not using very good
machining process and they work as old type of technique. We are going to design and making a
new die to reduce the wastage of raw material and reduce a processing & machining time to an
improve the quality of hinge product.

Downloads

Published

2016-04-25

How to Cite

Dhruv A. Patadiya, Jayvirsinh A. Zala, ignesh R. Chauhan, & Jaspalsinh M. Rana. (2016). TO IMPROVE THE QUALITY OF HINGE PRODUCT AND REDUCE THE RATE OF REJECTION AND WASTAGE ON POWER PRESS MACHINE. International Journal of Advance Research in Engineering, Science & Technology, 3(4), 49–52. Retrieved from https://ijarest.org/index.php/ijarest/article/view/506

Issue

Vol. 3 No. 4 (2016): Volume: 03, Issue: 04 - April, 2016.

Section

Articles