Analytically and by Using Ansys Stress analysis in base plate with different cut-out section

Authors

  • Sorathiya Mehul (PhD Scholar C U Shah University)
  • Vishal Solanki Mechanical Dept., Sigma institute of Engineering
  • Vivek Brambhatt Mechanical Dept., Sigma institute of Engineering

Keywords:

deformation, different cut-out, equivalent stress, steel

Abstract

This paper aims to study on base plate located at base of tank, which is filled with milk. The plate contains a circular
hole presently. Stress analysis for different hole geometry has been done. The results based on analytical solution are
compared with the results obtained using finite element methods by utilizing ANSYS 14 software. The main
objective of this study is to demonstrate the effect of various shaped cut-out in plate . In addition, effect of cut-out
geometry (circular, square, rectangle, triangle or special cut-outs), material properties (isotropic and orthotropic),
fibre angles, and cut-out curvature are considered to observe the behavior of plate.

Downloads

Published

2015-12-25

How to Cite

Sorathiya Mehul, Vishal Solanki, & Vivek Brambhatt. (2015). Analytically and by Using Ansys Stress analysis in base plate with different cut-out section. International Journal of Advance Research in Engineering, Science & Technology, 2(12), 50–54. Retrieved from https://ijarest.org/index.php/ijarest/article/view/353

Issue

Vol. 2 No. 12 (2015): Volume: 02, Issue: 12 - December, 2015.

Section

Articles