Analysis of rubber bush mould Using Mould-Flow and compare with experimental result

Abstract

This With increasingly short life span on consumer electronic products such as mobile phones are becoming more fashionable,
injection molding remains- the most popular method for producing the associated plastic parts. The process requires a molten
polymer being injected into a cavity inside a mold, which is cooled and the part ejected. The main phases in an injection molding
process therefore involve filling, cooling and ejection. The cost-efficiency of the process is dependent on the time spent in the
molding cycle. Die design is the most time consuming stage, so here mouldflow is used to analyze die design and for testing
mouldflow result, comparison have been done with experimental design..