Effect of WEDM process parameters on Fe-703 Low Alloy steel using Factorial Method

Authors

  • Brajesh Kumar Lodhi Mechanical Engineering, BIET, Jhansi-284128
  • Ganga Sagar Singh Mechanical Engineering, Dr. BRAECIT, Banda

Keywords:

WEDM; Factorial method; ANOVA; MRR, Ra

Abstract

Wire Electrical discharge machining (WEDM) is a non-traditional manufacturing technique that has been widely used in
generation of contour profiles, manufacturing of automotive, aerospace and surgical components. The most important
performance measure in WEDM is the MRR and surface roughness. In this study, the experimental studies were conducted under
varying pulse-on-time (TON), pulse-off-time (TOFF), peak current (IP) and wire feed (WF). Experimentation has been done by using
Factorial method under different condition of parameters. To validate the study, confirmation experiment has been carried out at
optimum set of parameters and predicted results have been found to be in good agreement with experimental findings.

Downloads

Published

2015-08-25

How to Cite

Brajesh Kumar Lodhi, & Ganga Sagar Singh. (2015). Effect of WEDM process parameters on Fe-703 Low Alloy steel using Factorial Method. International Journal of Advance Research in Engineering, Science & Technology, 2(8), 15–18. Retrieved from https://ijarest.org/index.php/ijarest/article/view/269

Issue

Vol. 2 No. 8 (2015): Volume: 02, Issue: 08 - August, 2015.

Section

Articles