Identification of casting product defects &its improvement Remedies: Review

Authors

  • Manan Ganatra B.E Mechanical Department ,Parul institute of technology, vadodadara
  • Shivam bhatt B.E Mechanical Department ,Parul institute of technology, vadodadara
  • Arjun Fadadu B.E Mechanical Department ,Parul institute of technology, vadodadara
  • Ankit Dindor B.E Mechanical Department ,Parul institute of technology, vadodadara

Keywords:

Steel Casting, Shrinkage defects, gas defects, mold and melting furnace

Abstract

In this paper the statistical analysis is aimed to optimize process parameters at the case study i.e R A
ALLOY STEEL, VADODARA, GUJARAT to minimize the major cast iron. This project is intended to observe just
of steel casting & cat iron defects which are severe in nature in their nature i.e. ., directional solidification,
misalignment & surface finishing. In order to minimize these defects, process parameter ere studied like –gas
defects, Mold permeability, Pouring Temperature, Directional solidification, Misrun. In order to obtain a
representative experimental data it was used as factorial experiment. The relative influence of each factor on the
casting defect/porosity/ was determined and suggestions have been given using the Statistical Analysis method by
optimizing the process parameters.

Downloads

Published

2018-04-25

How to Cite

Manan Ganatra, Shivam bhatt, Arjun Fadadu, & Ankit Dindor. (2018). Identification of casting product defects &its improvement Remedies: Review. International Journal of Advance Research in Engineering, Science & Technology, 5(4), 415–420. Retrieved from https://ijarest.org/index.php/ijarest/article/view/1483

Issue

Vol. 5 No. 4 (2018): Volume: 05, Issue: 04 - April, 2018.

Section

Articles